Sharp Display LQ092B5DW01
Hiermit fing alles an [1]
Was braucht man?
- Display
- Raspberry Pi
- Step-Up Converter für die Hintergrundbeleuchtung
- Adapterplatine von 0.5mm Flexbandkabel auf "normalen" 2.54mm Pinabstand
- 0.5mm 40 poliges Flexbandkabel
Nützliche Infos
config.txt
# For more options and information see # http://www.raspberrypi.org/documentation/configuration/config-txt.md # Some settings may impact device functionality. See link above for details # uncomment if you get no picture on HDMI for a default "safe" mode #hdmi_safe=1 # uncomment this if your display has a black border of unused pixels visible # and your display can output without overscan #disable_overscan=1 # uncomment the following to adjust overscan. Use positive numbers if console # goes off screen, and negative if there is too much border #overscan_left=16 #overscan_right=16 #overscan_top=16 #overscan_bottom=16 # uncomment to force a console size. By default it will be display's size minus # overscan. #framebuffer_width=1280 #framebuffer_height=720 # uncomment if hdmi display is not detected and composite is being output #hdmi_force_hotplug=1 # uncomment to force a specific HDMI mode (this will force VGA) #hdmi_group=1 #hdmi_mode=1 # uncomment to force a HDMI mode rather than DVI. This can make audio work in # DMT (computer monitor) modes #hdmi_drive=2 # uncomment to increase signal to HDMI, if you have interference, blanking, or # no display #config_hdmi_boost=4 # uncomment for composite PAL #sdtv_mode=2 #uncomment to overclock the arm. 700 MHz is the default. #arm_freq=900 # Uncomment some or all of these to enable the optional hardware interfaces #dtparam=i2c_arm=on #dtparam=i2s=on #dtparam=spi=on # Uncomment this to enable the lirc-rpi module #dtoverlay=lirc-rpi dtoverlay=dpi18 # Additional overlays and parameters are documented /boot/overlays/README # Enable audio (loads snd_bcm2835) dtparam=audio=on #core_freq=250 #sdram_freq=450 #over_voltage=2 dtparam=spi=off dtparam=i2c_arm=off #Overscan Information. #overscan_left=0 #overscan_right=0 overscan_top=6 #overscan_bottom=0 framebuffer_width=960 framebuffer_height=160 #Enable the lcd, enable custom display sizes with CVT, set as the default output. enable_dpi_lcd=1 dpi_group=2 dpi_mode=87 # Hdmi CVT display_default_lcd=1 dpi_output_format=458773 hdmi_timings=960 0 40 48 88 160 0 13 3 32 0 0 0 60 0 31253817 3